Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-1022001.png)
Fluid Pump: Service and Repair
24 11 012 Removing and installing/sealing or replacing transmission fluid sump (AISIN)
Necessary preliminary tasks:
Secure engine in installation position.
Raise engine and transmission.
Note:
After completion of work, check transmission fluid level.
Make a note of drained ATF quantity.
Required replenishment quantity approx. 4.5 liters.
Important!
Use only the approved automatic transmission fluid in this automatic transmission.
Otherwise the automatic transmission may incur extensive damage!
Do not drain fluid before the transmission has cooled down.
Remove underbody protection (1).
Release screw (2).
Drain off transmission fluid.
Unscrew bolt (3).
Drain off transmission fluid.
Tighten drain plug to oil sump/transmission
M10 ................................................................................................................................................................................................................... 27 Nm
M18 ........................................................................................................................................................................................................ 23.5 + 10 Nm
Installation:
Replace seals.
