Cooper Convertible (R52) L4-1.6L (W10) (2005)
Installation note:
Check dowel sleeves (1) for damage and replace if necessary.
The must be no oil or coolant in the tapped holes for the cylinder head bolts in the cylinder block.
If necessary, clean out holes with compressed air.
Replace cylinder head gasket.
Pay attention to adjustment (1) of cylinder head gasket.
Install cylinder head.
Insert cylinder head bolts (1 to 10) and tighten down in sequence (1-10).
Tightening torque:
1st stage: 40 Nm
2nd stage: 90°
Insert cylinder head bolts (11 to 12) and tighten down in sequence (11-12).
Tightening torque: 28 Nm.