Cooper Convertible (R52) L4-1.6L (W10) (2005)
RDW system
When a tire pressure warning light is observed, Check and inflate tire(s) to specified pressures. After correcting the air pressure with the engine off
and the ignition on, press the "Set" button and hold (approx. 6 seconds) until the words "Set tire pressure" appear in the instrument cluster (instrument
cluster high) or the yellow LED lights up (basic instrument cluster).
Set button
Installed in the dashboard to the right of the steering wheel.
Symbol:
Tire cross-section with warning triangle.
Task:
Initialization after resetting cold tire pressure or after changing tire or wheel location.
RPA Warning System
The RPA system has three ways of resetting/initialization dependent on the model/interface. (RPA initialization means "teaching the system the tire
pressures".)
-
RPA button >E46,E53,E83,E85
The RPA button only needed for initializing the RPA.
-
CID: Central Information Display
Vehicles that are equipped with CID are initialized using the CID.
-
On-board button and rocker switch on direction indicator/high beam stalk > E87, E90, E91
Initialization is performed on the LC display, using the BC button and the rocker switch on the turn-signal/main-beam switch. The on-board
computer functions are selected with the rocker switch.
The Run Flat Indicator (RPA) is initialized using the following control elements:
-
RPA button