Cooper Convertible (R52) L4-1.6L (W10) (2005)
Release lock and tilt back or swing away mounting pillar.
Unclamp and clean rim.
Replace valve.
Coat bead seat and tire beading with mounting paste (refer to BMW Parts Service).
Clamp rim on tire fitting machine.
Fit tire while pushing lower bead partly over the bead seat.
The valve is positioned about 10 cm to the right of the mounting head.
Swing or tilt mounting pillar into position and lock.
Check alignment of mounting finger, correct and tension as required.
Press tire under mounting finger by hand.
The tire bead should fit in rollers next to mounting finger.
Allow fitting machine to run a forward for a short distance (clockwise).
The lower tire bead now slips into the rim well.