Cooper Convertible (R52) L4-1.6L (W10) (2005)
/l4-1.6l_(w10)/Page-509007.png)
Fitting - upper bead:
Position sensor (1) in relation to fitting head (2) as pictured.
Important!
Make sure tire is correctly positioned on fitting head. Position bead in relation to fitting head (2) in accordance with equipment manufacturer's
instructions.
Position sensor (RDC) (1) and valve min. 10-15 cm before traction point/catching point.
Sensor must not be subjected to load.
Coat bead holding-down element (3) with antiseize compound and insert.
Allow fitting machine to rotate slowly.
Insert additional bead holding-down elements (1) to hold the bead in the well.
The last part of the bead should jump over the rim flange in the sensor area.
Important!
Perform fitting in stages, take short breaks and relieve tension.
Avoid heavy deformations at the traction point.
Do not squash belt edge and sidewalls through holding-down elements.
Never use a tire iron as a holding-down element.
