Cooper Convertible (R52) L4-1.6L (W10) (2005)
/l4-1.6l_(w10)/Page-295001.png)
Impact Sensor: Service and Repair
Removing and Installing/Replacing Impact Sensor for Left or Right Side Airbag
65 77 551 - Removing and installing (replacing) impact sensor for left or right side airbag
Warning!
Note airbag safety instructions! See: Restraint Systems/Air Bag Systems/Service Precautions/Safety Regulations For Handling Airbag System
Components
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
-
Remove rear side trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Removing and Installing Rear Left or
Right Side Trim Panel
Unfasten plug connection (1) and disconnect.
Release screws (2), tightening torque 65 77 2AZ See: Restraint Systems/Air Bag Systems/Specifications/65 77 Airbag control unit and airbag sensors.
Remove impact sensor for side airbag (3).
Installation Note:
Arrow (4) on impact sensor for side airbag (3) must point in direction of entrance.
Replacement:
Carry out programming/coding See: Testing and Inspection/Programming and Relearning/Vehicle Programming and Coding.
