Cooper Convertible (R52) L4-1.6L (W10) (2005)
Ball Joint: Service and Repair
31 12 042 - Removing and installing/replacing ball joint for control arm
Special tools required:
-
31 2 240 See: Tools and Equipment/31 2 240 Puller
Necessary preliminary tasks:
-
Remove drive shaft
-
If necessary, remove ride-height sensor See: Sensors and Switches - Suspension/Ride Height Sensor/Service and Repair/Replacing Front
Ride-Height Sensor
After completing tasks carry out wheel alignment.
Release nut and detach control arm with special tool 31 2 240 See: Tools and Equipment/31 2 240 Puller.
Installation:
Replace self-locking nuts
Tightening torque 31 12 3AZ See: Control Arm/Specifications/Control Arms and Struts (Front).