Cooper Convertible (R52) L4-1.6L (W10) (2005)
Front Subframe: Service and Repair
31 11 001 - Replacing front axle support
Necessary preliminary tasks:
-
Remove front wheels See: Wheels and Tires/Wheels/Service and Repair/Removal and Replacement/Removing or Installing Front or Rear Wheel
-
Remove bumper bracket See: Body and Frame/Bumper/Front Bumper/Front Bumper Bracket/Service and Repair/Removing and
Installing/Replacing Bumper Bracket
-
Remove underbody protection See: Body and Frame/Splash Guard/Service and Repair
-
Remove stabilizer link See: Stabilizer Bar/Service and Repair/Front Axle/Removing and Installing/Replacing Push Rod (Stabilizer Link) for
Left/Right Stabilizer from stabilizer
-
Remove tie rods See: Steering/Tie Rod/Service and Repair from swivel bearing
-
Remove control arm See: Control Arm/Service and Repair/Front Axle/Removing and Installing Left or Right Control Arm from swivel bearing
After completing work, carry out electronic wheel alignment check.
Unscrew nuts (1).
Installation:
Replace self-locking nuts.
Tightening torque 32 41 8AZ See: Steering/Specifications/Pump and Oil Supply.
Release nut (2) and remove bracket from supply reservoir.
Installation:
Replace self-locking nuts.
Tightening torque 32 41 9AZ See: Steering/Specifications/Pump and Oil Supply.