Cooper Convertible (R57) L4-1.6L (N12) (2009)
Insert valve insert with wheel electronics into cleaned valve bore.
Here the radial bore (1) for gripping on the circumference of the valve insert ball head must point outwards.
Insert the brace (1) supplied with the valve into the valve insert bore.
Fit new washer and screw on new union nut (2) by hand as far as it will go.
Important!
The screw connection must be tightened to the specified torque in one go!
Do not under any circumstances retighten the screw connection!
Remove brace, otherwise it may damage the tire.
Tighten down union nut (2) while using brace (1) to prevent valve insert from turning.
Installation Note:
Tightening torque 36 11 1AZ.