Cooper Convertible (R57) L4-1.6L (N12) (2009)
Important!
Tightening to torque must be effected by means of the screw!
Support swivel bearing with workshop jack.
Slacken nut (2).
Tightening torque 31 31 3AZ See: Suspension/Suspension Strut / Shock Absorber/Specifications/Spring Struts (Front).
Pull out screw (1) towards rear and remove swivel bearing.
Installation Note:
Keep swivel bearing to spring strut connection clean and free from oil and grease.
Note insertion direction of screw.
Replace self-locking nuts.
Replacement:
-
Modify wheel bearing See: Suspension/Wheel Bearing/Service and Repair/Front Axle
-
Modify brake carrier/guard plate See: Brakes and Traction Control/Disc Brake System/Service and Repair
After installation:
-
Replacement only: Perform chassis alignment check