Cooper S (R53) L4-1.6L SC (W11) (2004)
end at same height.
Note: Small areas of seal can remain stuck to adhesive tape of loose end.
f.
Pressing on seal:
-
Press on seal using a roller
-
Adhesive tape width up to 5 mm Application pressure approx. 5 N
-
Adhesive tape width up to 10 mm Application pressure approx. 10 N
Sliding sunroof seal only: - Press against seal strongly with a roller. Application pressure approx. 70 N.
E36 sliding sunroof seal only:
-
Application pressure approx. 30 N.
-
Tear off tear-off lip at rear and side in area of narrower flange.
Note: Firm thumb pressure has approx. 35 N/cm(2)
3. Checking rubber seal
-
Check the bonded seals for correct positioning and perfect adhesion. The bonding can be checked by pressing back the sealing lip.
-
The force required to peel off the seal immediately after gluing must be greater than 10 N/cm.