Cooper S (R56) L4-1.6L Turbo (N14) (2009)
IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be
observed without fail.
Removing badge:
Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322.
Fitting badge:
Pull liner* off adhesive tape (1), position badge over guide pins (2) on rear lid and press down firmly.
* Liner is the protective film on a new badge.
51 14 110 Removing and Installing/Replacing Rear Model Designation
51 14 110 Removing And Installing/Replacing Rear Model Designation