Cooper S (R56) L4-1.6L Turbo (N14) (2009)
IMPORTANT:
-
Retaining strip (1) has an aluminium profile insert (2).
-
Carefully wind out retaining strip (1) (windscreen breakage).
3 Glue bead
4 Windscreen
Installation:
Clean windscreen.
Pay attention to centre marking on retaining strip (1) and windscreen.
Insert positioner (2) for retaining strip (1) must be removed after it has been fitted on the windscreen but before the windscreen itself is installed.
Replacement of retaining strip without windscreen removal:
If adhesive has managed to get onto retaining strip (1), this area must be cut out partially.
To facilitate installation, moisten body cutout with water and fit retaining strip.
Replacement of retaining strip with removed or new windscreen:
Fit rubber frame (1).
3 Aluminium strip
51 13 124 Removing and Installing/Replacing Right Cowl Panel Cover
51 13 124 Removing And Installing/Replacing Right Cowl Panel Cover
Remove gasket (1).
Release nut (2) and screw (3).
Unclip cover (4) towards top from retaining strip (5) and feed out.
Installation:
Make sure cover (4) is correctly seated on retaining strip (5).