Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-865005.png)
Disconnect plug connection (1) on clutch master cylinder.
Disconnect line connection (2).
IMPORTANT: Catch brake fluid in a suitable container.
Release screw (1).
Installation:
Tightening torque 35 11 AZ.
NOTE: Accessibility only with a 75 mm long extension (2).
Disconnect plug connection (1) on brake light switch.
Detach retaining clip (2) and press out pin in direction of arrow.
Installation:
Check retaining clip (2) and replace if necessary.
Make sure retaining clip (2) is correctly engaged.
Release nuts (3) and remove complete bearing support towards bottom.
Installation:
