Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-878001.png)
Brake Rotor/Disc: Service and Repair
34 11 220 Removing and Installing or Replacing Both Front Brake Discs
34 11 220 Removing and installing or replacing both front brake discs
Important:
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
Necessary preliminary tasks:
^
Remove front brake-pads
After completing work, read and comply with notes on braking in new brake discs / brake pads.
Release screws (1).
Remove brake caliper with brake anchor plate in direction of arrow and tie up.
Installation: Tighten brake caliper to steering knuckle
2AZ Brake caliper to steering knuckle
M12 ................................................................................................................................................................................................................. 110 Nm
Release screw (1) and remove brake disc.
Installation:
Replace screw (1).
Tighten brake disc to wheel hub
1AZ Brake disc to wheel hub (contact faces between brake disc and wheel hub clean and grease-free)
M10 x 13 Torx screw ........................................................................................................................................................................................ 27 Nm
Clean contract face of wheel hub thoroughly and remove any traces of rust if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
Important: When removing the brake disc: On no account strike the friction ring with a hammer or similar object! If necessary, carefully tap
with a rubber hammer against the brake disc nave.
