Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-357005.png)
Tighten bolts (1 to 10).
Tighten Main bearing screws, observe tightening specification
1AZ Main bearing screws, observe tightening specification.
M9x115
Jointing torque ................................................................................................................................................................................................... 30 Nm
Torque angle ........................................................................................................................................................................................................ 150 °
Note: Replace screws
Tighten bolts (11 to 28).
Tighten Bedplate, observe tightening specification
2AZ Bedplate, observe tightening specification.
M6
Jointing torque ..................................................................................................................................................................................................... 9 Nm
Note: Replace screws
Tighten bolts exclusively with special tool 00 9 120.
Important:
Jointing torque and angle of rotation must be observed without fail.
