mini Workshop Repair Guides

Mini Workshop Service and Repair Manuals

Towing Information|Service and Repair|Page 2650 > < Jump Starting|Service and Repair
Page 1
background image

Towing Information: Service and Repair

TOW-STARTING AND TOWING 
 

 

For towing, use either a tow bar or a nylon rope or nylon belts that prevent sudden jerking movements.

Tow fitting 

The screw-in tow fitting is stored in the onboard tool kit; be sure that it remains in the vehicle at all times. This fitting is designed for installation in the
tow sockets located at the front and rear of the vehicle. It is intended for towing on paved road surfaces only.

Access to tow sockets 

Use a suitable object (e.g. credit card) to press out the covers from the recess.

Caution! 

Screw the tow fitting in until it bottoms firmly. lfthis is not done, the threads could be damaged. Never attach tie-down hooks, chains,
straps, or tow hooks to tie rods, control arms, or any other part of the vehicle suspension, as severe damage to these components will
occur, leading to possible accidents.

Towbars 

If the tow fittings ofthe two vehicles are not directly opposite one another, please note:
-

Clearance and maneuvering capability will be strictly limited in corners.

-

The inclination of the tow bar generates lateral force (critical above all if the road surface is slippery).

Caution! 

Do not tow a vehicle that is heavier than the towing vehicle, otherwise it will no longer be possible to control vehicle response.

Tow-starting 

Caution! 

On vehicles with automatic transmissions, it is not permitted to start the engine by tow-starting. The transmission could be damaged. 

Only tow-start vehicles with a catalytic converter when the engine is cold, otherwise, unburned fuel in the catalytic converter could catch fire. It is
better to use jumper cables.

1.  Switch on the hazard warning system (comply with national regulations).
2.  Ignition key in position 2.
3.  Engage 3rd gear.
4.  Tow-start with the clutch pedal pressed.
5.  Slowly release the clutch.
6.  When the engine starts, press the clutch pedal again.
7.  Switch off the hazard warning system. 
Have the cause of the starting problems rectified by your MINI center.

Towing 

Caution! 

Only tow vehicles with automatic transmission with the front wheels raised or on a special transport vehicle, otherwise the transmission
can be damaged.

1  Ignition key in position 1:

The brake lamps, turn signals, horn and windshield wipers can be operated

Towing Information|Service and Repair|Page 2650 > < Jump Starting|Service and Repair