Cooper S Convertible (R57) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-427005.png)
Slide on tire with lower bead partially over rim flange.
Swing or tilt mounting pillar into position and lock.
Check adjustment of mounting finger, readjusting if necessary, and clamp.
Press tire under mounting finger by hand.
Tire bead must seat in rollers next to mounting finger.
Let fitting machine run forward (clockwise) a short distance.
Lower tire bead will drop into well.
Important!
Vehicles with RDC:
Mount lower tire bead so that no pressure forces are exerted on RDC wheel electronics.
Turn wheel again into fitting position so that valve is at 180° to mounting head.
Press upper tire bead under mounting finger. Bead must seat in rollers next to mounting finger.
Important!
Do not pinch or damage bead.
Operate fitting machine forwards (clockwise) little by little; while doing so, make sure the lower tire bead remains in the well.
Important!
Vehicles with RDC:
Mount upper tire bead so that no pressure forces are exerted on RDC wheel electronics.
