Cooper S Convertible (R57) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-753001.png)
Knock Sensor: Service and Repair
12 14 600 - Replacing knock sensor (N12, N14)
Necessary preliminary tasks:
-
Switch off ignition
-
Read out fault memory of DME control unit
-
Check stored fault messages
Installation location:
The knock sensor is located under the intake manifold next to the starter motor.
Unlock plug (1) and remove.
Release screw and remove knock sensor (2).
Installation:
Clean contact surface of knock sensor on engine block.
Tightening torque 13 62 2AZ See: Fuel Delivery and Air Induction/Specifications/13 62 Senders for Control Unit.
Note:
Now clear the fault memory.
