Cooper S Convertible (R57) L4-1.6L Turbo (N14) (2009)
-
Install brake tensioner.
-
Perform input measurement in accordance with equipment manufacturer's instructions.
-
Compare specified values with actual values.
Only in event of customer complaint (e.g. poor driving performance):
Important!
Do not remove screws/bolts (front axle carrier to engine carrier/body).
Slacken all screws/bolts (front axle carrier to engine carrier/body) and then retighten to specified torque.
Refer to Lowering front axle carrier.
-
If necessary, adjust front axle and rear axle
-
Perform output measurement in accordance with equipment manufacturer's instructions.
-
Save and print out test record.
-
Version with Dynamic Stability Control (DSC): Carrying out steering angle sensor adjustment
-
Insert locking pins into both rotary and sliding plates
-
Remove chassis/wheel alignment system
KDS Chassis/Wheel Alignment Check with Ride-Height Measurement without Load
32 00 155 - KDS chassis/wheel alignment check with ride-height measurement without load