3000GT V6-2972cc 3.0L DOHC (1993)
Voltage Signal: Testing and Inspection
Battery Voltage Signal
Back-up And Voltage Signal Circuit
To test the battery back-up and voltage signal, proceed as follows.
1. Using a volt meter, check the voltage between ECU harness terminal 60 and ground.
Voltage
System voltage.
2. Disconnect the negative battery cable and the ECU connector.
3. Using an ohm meter, check for continuity between the positive battery terminal and ECU harness terminal 60.
Continuity
Should exist.
4. Using an ohm meter, check for continuity (SHORTS) between chassis ground (not the negative battery terminal) and ECU harness terminal 60.
Continuity
Should not exist.
If any of the previous tests produce unsatisfactory results, the harness will need to be repaired or replaced. Once repairs have been completed,
confirm that the repair has corrected the problem. SEE CHASSIS ELECTRICAL DIAGRAMS.
If the trouble returns, it is possible that there is an intermittent failure of the component or the ECU. Check for looseness at all harness junctions and
test for an intermittent failure.
