3000GT V6-2972cc 3.0L DOHC (1993)
(4) Measure the backlash between the side gears and pinions.
Standard value: 0.025 - 0.150 mm (0.001 - 0.006 in.)
(5) If the backlash is out of specification, disassemble again and using correct spacer, reassemble and adjust.
CAUTION: Adjust for same backlash of both side gears.
B. LOCK PIN INSTALLATION
(1) Align the pinion shaft lock pin hole with the case lock pin hole and insert the lock pin.
CAUTION:
-
Do not reuse the lock pin.
-
The lock pin head must be sunk from the flange surface of the differential case.
C. TAPER ROLLER BEARINGS INSTALLATION
CAUTION: When press-fitting the bearings, push the inner race only.