3000GT AWD V6-2972cc 3.0L DOHC Turbo (1991)
3.
Replace camshaft oil seals in numbered sequence shown in Fig. 37, noting the following:
a. Using a suitable wrench on hexagonal part of camshaft, loosen camshaft sprocket bolt.
b. Cut out a portion in camshaft oil seal lip, Fig. 38.
c. Cover tip of a suitable screwdriver with a clean soft cloth and pry out seal at cut out portion of seal. Use care not to damage camshaft or
cylinder head.
4.
Reverse numbered sequence shown in Fig. 37 to install, noting the following:
a. Apply small amount of engine oil to seal lip.
b. Using camshaft oil seal installer tool No. MD998761 or equivalent, insert oil seal.
c. Using a suitable wrench on hexagonal part of camshaft, tighten camshaft sprocket pulley bolt to specification.
d. Tighten rocker cover bolts in order shown in Fig. 39. Only No. 5 bolt in rear bank differs from other bolts in length, rear bank No. 5 bolt
is .79 inch long and remaining bolts in rear bank are .39 inch long. Bolts are color coded for installation, front bank bolts are black
and rear bank bolts are green. When rocker cover gasket has been replaced, tighten bolts in this order and then torque bolts one to six
to 2.9 ft. lbs.
