3000GT AWD V6-2972cc 3.0L DOHC Turbo (1991)
Idle Speed: Adjustments
Base Idle Speed
NOTE: Adjustment of idle speed is usually not required. If idle speed is out of specification check and verify the operation of the idle speed control
system. Refer to Computers and Control Systems.
1.
Precondition the vehicle as follows:
a. Engine coolant temperature greater than 185 degrees F.
b. Lights, electric cooling fan, and all electrical accessories off.
c. Transmission in neutral or park.
d. Steering wheel in the neutral position.
e. Ignition timing verified correct.
Tachometer Lead Connector Location
2.
Insert a paper clip in the idle speed connector (blue).
Tachometer Installed
3.
Connect a tachometer to the inserted paper clip.
NOTE: The tachometer should read at 1/3 of the actual engine speed. Multiply the reading by 3 to obtain the correct RPM.
Data Transmission Selector Terminal Identification
4.
Use a jumper wire, ground the self diagnosis/data transfer switching terminal (terminal 10) of the diagnostic connector (white). The connector is
located inside the passenger compartment, under the dash, adjacent to the left kick panel.
