3000GT AWD V6-2972cc 3.0L DOHC Turbo (1991)
4.
Remove two screws holding the turn signal switch to the column switch assembly. The screws are located at the top center and bottom center of
the turn signal switch. Refer to Figure 1.
5.
Separate the turn signal switch from the column switch assembly, but do not disconnect the turn signal harness. Refer to Figure 2.
6.
Observe the four screws on the front plate of the turn signal switch. Loosen, but do not remove the two inboard screws. Refer to Figure 3.
NOTE:
To avoid internal damage to the turn signal switch, do not remove any of the four screws attaching the front plate to the main body.