3000GT AWD V6-2972cc 3.0L DOHC Turbo (1991)
HARNESS TEST
1. With the ignition switch in the off position, check for continuity between the ignition timing adjustment connector and ground.
CONTINUITY:
Should Not Exist
2. Turn ignition switch to the on position.
3. Connect a volt meter between the ignition timing adjustment connector and ground.
3. Measure the voltage.
VOLTAGE:
4.0 - 5.2 Volts
If any of the previous tests produce unsatisfactory results, the harness will need to be repaired or replaced. Once repairs have been completed, clear
the trouble codes and road test the vehicle to confirm that the repair has corrected the problem and the code doesn't return.
If the same trouble code reoccurs, it is possible that there is an intermittent failure of the component or the ECU. Check for looseness at all harness
junctions and test for an intermittent failure.
