3000GT AWD V6-2972cc 3.0L DOHC Turbo (1991)
6.
Reassemble the speedometer gear/sleeve using the new driven gear (p/n MR111502). Apply a small amount of gear oil to the driven gear shaft
before inserting it into the sleeve.
When installing the spring pin, be sure to position it with its split facing the speedometer sleeve, NOT the shaft of the driven gear.
7.
Install the speedometer gear/sleeve assembly, making sure the driven gear meshes correctly with the speedometer drive gear in the transaxle.
Tighten the speedometer sleeve bolt 4 N-m (3 ft.lbs.).
8.
Attach the speedometer harness to the speedometer gear.
9.
Install the battery, battery shield, and battery hold-down.
10.
Re-set the radio and the clock.
11.
Test drive the vehicle to check for speedometer gear noise. If noise is heard, re-check the gear installation for proper fit and carefully reassemble
as needed.
PARTS INFORMATION