3000GT AWD V6-2972cc 3.0L DOHC Turbo 24 Valve (1996)
d. Install the camshafts with their dowel pins positioned as shown in the illustration.
Note:
a. Install the bearing caps according to the identification mark and cap number. No.2, 3. and 4 bearing caps bear the front mark. Install these caps
with the front mark directed in the same direction as that on the cylinder head.
Identification mark: <Intake> I <Exhaust> E
b. Gradually tighten the bearing caps in two or three steps. In the final step, tighten to the specified torque. Tighten the front and rear bearing cap
bolts to 20 Nm (14 ft. lbs.) and bearing cap Nos. 2, 3 and 4 to 11 Nm (8 ft. lbs.).
4. Bearing cap, No.3.
5. Bearing cap, No.4.
6. Bearing cap, No.2.
7. Bearing cap, rear.
8. Bearing cap, front.
