3000GT AWD V6-2972cc 3.0L DOHC Turbo 24 Valve (1996)
HARNESS INSPECTION PROCEDURE
ACTUATOR INSPECTION
NOTE: When disconnecting the vacuum hose, make an identification mark on it so that it can be reconnected to the original position.
(1) <Up to 1995 models>
Disconnect the vacuum hose (yellow and green stripe) from the solenoid.
<From 1996 models>
Disconnect the vacuum hose (yellow and white stripe) from the solenoid.
(2) Disconnect the harness connector.
(3) <Up to 1995 models>
Connect a hand vacuum pump to the nipple to which the green-striped vacuum hose was connected.
<From 1996 models>
Connect a hand vacuum pump to the nipple to which the white-striped vacuum hose was connected.
(4) Apply a vacuum and check for air-tightness when voltage applied directly to the EGR solenoid and when the voltage is discontinued.
(5) Measure the resistance between the terminals of the solenoid.
Standard value: 36-44 Ohms [at 2O°C (68°F)]
