3000GT Convertible AWD V6-2972cc 3.0L DOHC Turbo (1995)
A. Remove the nuts and bolts securing the low-pressure hose shown in the illustration above and, using a wire, suspend the hose from the hood to a
position where it does not hamper the removal and installation of the brake booster.
Caution: Move the hose slowly with care not to bend it.
Installation:
A. In the case of AWD, install the vacuum hose to the rake booster nipple as shown in the image above. Secure the hose with the hose clip. Install the
other end of the vacuum hose fully onto its port on the engine. Secure the hose using the hose clip.
Caution: The check valve and the pipe part of the brake booster must not contact each other.
A. Adjust the clearance (A) between the brake booster pushrod and primary piston as follows:
-
Measure the dimension (B) between the master cylinder end face and piston. Note that to obtain (B), first take measurement with a square
placed on the master cylinder end face. Then, subtract the thickness of the square to arrive at (B).
