3000GT Convertible AWD V6-2972cc 3.0L DOHC Turbo (1995)
Fig. 7 Bearing Installer Tool Installation
a. Install front hub remover and installer tool No. MB990998-01, or equivalent, on the front hub unit bearing, Fig. 7.
b. While holding tool bolt, tighten to specification.
c. Turn hub to seat bearing in grease.
Fig. 8 Hub Torque Measurement
d. Measure rotation starting torque and ensure it is 16 inch lbs. or less, Fig. 8.
4. Reverse procedure to install, noting the following:
Fig. 3 Washer Installation
a. Ensure washer and wheel bearing nut are installed as shown, Fig. 9.
b. After installing wheel, lower vehicle and tighten nut to specifications.
c. If position of cotter key holes does not line up, tighten to specification.
d. Install cotter key.
