3000GT SL V6-2972cc 3.0L DOHC MFI (1997)
Cruise Control Servo Cable: Testing and Inspection
Physical Inspection
INSPECT
(1) Set the air conditioning, lights and other switches to OFF for inspection at no load.
(2) Let the engine warm up until it runs at idle.
(3) Check that the idle speed is within the specified range.
(4) Stop the engine and set the ignition switch to OFF.
(5) Check that the accelerator cable, cruise control cable and throttle cable are routed without sharp bends.
(6) Depress the accelerator pedal to check that the throttle lever moves smoothly from the fully-closed to fully-opened position.
(7) Check the free travel state of the inner cables of the accelerator cable, cruise control cable and throttle cable.
(8) If the inner cables are too loose or have no free travel at all, check using the following procedure.
ADJUST
(1) Remove the link protector.
(2) Loosen the adjusting and lock nuts of the throttle lever and intermediate links A, B and C to place the throttle lever and intermediate links A, B
and C in the free state.
(3) Set the ignition switch to ON (do not start the engine).
