3000GT SL V6-2972cc 3.0L DOHC MFI (1997)
Throttle Position Sensor: Adjustments
ADJUSTMENT
1. Connect the MUT-II to the diagnosis tester. If the MUT-II is not used, carry out the following.
a. Disconnect the throttle position sensor connector.
b. Using jumper wires, connect an ohmmeter across terminal (3) (closed throttle position switch) and terminal (4) (sensor ground) of the throttle
position sensor.
2. Insert a 0.65 mm (0.025 in.) feeler gauge between the fixed SAS and throttle lever.
3. If the MUT-II is used, turn the ignition switch to ON position. (Do not start the engine.)
4. Loosen the throttle position sensor mounting bolts and turn the throttle position sensor body fully counterclock wise.
5. In this condition, check that the idle switch is ON, continuity exists between terminals (3) and (4).
