3000GT SL V6-2972cc 3.0L DOHC MFI (1997)
k. Oil seal installation (17).
Using the special tool, press the oil seal into the valve housing.
CAUTION: In order to eliminate a seal malfunction at the valve housing alignment surface, the upper surface of the oil seal should project
outward approximately 1 mm (.04 inch) from the housing edge surface.
l.
End plug installation (10).
1. Apply the specified semi-drying sealant to the threaded part of the end plug.
Specified sealant: 3M ATD Part No. 8663 or equivalent.
2. Secure the threaded portion of the end plug at two places by using a punch.
m. Total pinion torque adjustment (-).
1. Position rack at its center. With special tool, tighten rack support cover to 15 Nm (11 ft. lbs.).
2. In neutral position, rotate pinion shaft clockwise one turn/4-6 seconds with special tool. Return rack support cover 30° - 60° and adjust
torque to the standard value.
Standard value: 0.6 - 1.3 Nm (5 - 11 inch lbs.)
CAUTION:
-
When adjusting, set the standard value at its highest value.
-
Assure no ratcheting or catching when operating rack towards the shaft direction.
NOTE: When it cannot be adjusted within the specified return angle, check rack support cover components or replace.
