3000GT SL V6-2972cc 3.0L DOHC MFI (1997)
Wheel Bearing: Testing and Inspection
END PLAY CHECK
1. Inspect the play of the bearings while the vehicle is jacked up and resting on floor jack.
2. Remove the hub cap and then release the parking brake.
3. Remove the caliper assembly and the brake disc.
4. Check the bearing's end play.
Place a dial gauge against the hub surface; then move the hub in the axial direction and check whether or not there is end play.
Limit: 0.05 mm (.002 inch) or less
NOTE: If the limit value is exceeded, the lock nut should be tightened to the specified torque and check the end play again.
5. Replace the rear hub bearing unit if an adjustment cannot be made to within the limit.
