Diamante V6-3.5L SOHC (2003)
Sunroof / Moonroof Clutch: Testing and Inspection
SLIDING FORCE OF SUNROOF MOTOR'S CLUTCH CHECK
Inspect the sliding force of the clutch by the following procedure.
1. Place the sunroof wrench from the on-board tools into the hexagonal socket of the sunroof motor drive shaft, and set a spring scale in a position
100 mm (3.94 in.) from the drive shaft.
2. Connect the battery to sunroof motor connector terminals 1 and 2 to rotate the sunroof motor.
3. Measure the spring scale reading when the rotating force of the sunroof motor equals the spring force of the spring scale.
Standard value: 47 - 62 N (7 - 9 lbs.)
CAUTION: The spring scale should be kept a right angle to the sunroof wrench.
CAUTION: If a wrench other than that in the on-board tools is used, the value for the clutch sliding force will be different, so only the on-board
tool should be used.
4. If the clutch sliding force is outside the standard value, replace the motor.
