Diamante V6-3.5L SOHC (2003)
Center Mounted Brake Lamp: All Technical Service Bulletins
Lighting - Center Mounted Stop Lamp Loose
No: TT-121-54-003
DATE: December 2005
MODEL: See Below
SUBJECT
CHMSL LOOSE
CHMSL Loose - 2002-04 Diamante with center high mount stop lamp. The CHMSL may become dislodged from the glass due to poor adhesion between
the attachment clips and the blackout portion of the glass. Remove and discard the old clips. Contact Tech Line to obtain two replacement attachment
clips, then reinstall the CHMSL as follows:
1. Thoroughly clean the mounting surfaces of the glass blackout and the clips with a cloth dampened with isopropyl alcohol.
2. Snap the clips to the CHMSL. Place it in position against the glass. Mark its position with two pieces of tape along the top and bottom edges.
3. Remove the CHMSL and apply a small amount of 3M Epoxy Adhesive 08107 (or equivalent) to the mounting surfaces of the new clips. Using the
tape as a guide, install the CHMSL.
4. Apply a piece of tape over the CHMSL to hold it in place while the adhesive dries (approximately one hour).
To submit warranty claims for this repair, use labor operation 54139095 for 0.3 hrs.
