Diamante V6-3.5L SOHC (2003)
Throttle Position Sensor: Adjustments
Without Traction Control
CLOSED THROTTLE POSITION SWITCH AND THROTTLE POSITION SENSOR ADJUSTMENT <Vehicles without TCL>
1. Connect the scan tool to the data link connector. When not using the scan tool, proceed as follows.
1. Disconnect the connector of the throttle position sensor.
2. Connect an ohmmeter between terminal 2 (closed throttle position switch) and 1 (sensor ground) by using jumper wires.
2. Insert a feeler gauge with a thickness of 1.4 mm (0.0551 in.) between the levers shown in the illustration to a depth of no more than 3 mm (0.1181
in.)
NOTE: Inserting the feeler gauge more than 3 mm (0.1181 in.) will result in incorrect adjustment.
3. When using the scan tool, turn the ignition switch ON. (Engine does not start.)
