Diamante V6-3.5L SOHC (2003)
Oxygen Sensor: Testing and Inspection
HEATED OXYGEN SENSOR CHECK
<Right bank and left bank heated oxygen sensor (front)>
1. Disconnect the heated oxygen sensor connector and connect the special tool (test harness) to the connector on the heated oxygen sensor side.
2. Make sure that there is continuity [4.5-8.0 Ohm at 20 °C (68 °F)] between terminal 1 (red clip of special tool) and terminal 3 (blue clip of special
tool) on the heated oxygen sensor connector.
3. If there is no continuity, replace the heated oxygen sensor.
4. Warm up the engine until engine coolant is 80 °C (176 °F) or higher.
5. Use the jumper wires to connect terminal 1 (red clip) of the heated oxygen sensor connector to the battery (+) terminal and terminal 3 (blue clip) to
the battery (-) terminal.
CAUTION: Be very careful when connecting the jumper wires; incorrect connection can damage the heated oxygen sensor.
6. Connect a digital voltage meter between terminal 2 (black clip) and terminal 4 (white clip).
7. While repeatedly racing the engine, measure the heated oxygen sensor output voltage.
8. If the sensor is defective, replace the heated oxygen sensor.
NOTE: For removal and installation of the heated oxygen sensor, refer to Exhaust Pipe and Main Muffler.
<Right bank and left bank heated oxygen sensor (rear)>
