Diamante V6-3.5L SOHC (2003)
Throttle Full Close Switch: Adjustments
With Traction Control
CLOSED THROTTLE POSITION SWITCH AND ACCELERATOR PEDAL POSITION SENSOR ADJUSTMENT
<Vehicles with TCL>
1. Connect the scan tool to the data link connector. When not using the scan tool, proceed as follows.
1. Disconnect the connector of the accelerator pedal position sensor.
2. Connect an ohmmeter between terminal 3 (closed throttle position switch) and terminal 4 (sensor ground) by using jumper wires.
2. Insert a feeler gauge with a thickness of 0.85 mm (0.0334 in.) between the levers shown in the illustration to a depth of no more than 3 mm
(0.1181 in.)
NOTE: Inserting the feeler gauge more than 3mm (0.1181 in.) will result in incorrect adjustment.
3. Turn the ignition switch to ON (but do not start the engine).
