Diamante V6-3.5L SOHC (2003)
1. Crush the oil seal in two places so that the tabs of the special tool can be engage on the wheel bearing inner race.
2. Remove the wheel bearing inner race from the front hub by using the special tool, as shown in the illustration.
3. Drive the wheel bearing out with a press, using a 61 mm (2.4 inch) installer adaptor.
SERVICE POINTS OF REASSEMBLY
>>A<< WHEEL BEARING
1. Fill the wheel bearing with multipurpose grease.
2. Apply a thin coating of multipurpose grease to the knuckle and bearing contact surfaces.
3. Press-in the bearing using the special tools.
>>B<< OIL SEAL (HUB SIDE)
