Diamante V6-3.5L SOHC (2003)
Rear Knuckle: Service and Repair
Rear Suspension Bushing Replacement
REAR SUSPENSION BUSHING REPLACEMENT
REMOVAL AND INSTALLATION
Required Special Tool:
MB99210701:
Rear suspension hushing replacer
1. Remove the wheel, stabilizer link connection nut and lower control arm assembly.
2. Fit special tool MB99210701 to the knuckle and remove the bushing as shown.
CAUTION:
The cut-away section of special tool should be positioned over the casting raised section to prevent tool misalignment.
3. Insert the bushing onto the special tool and press in the bushing until its end is flush with the knuckle. Observe bushing location through the cutout
section of the special tool.
