Diamante V6-3.5L SOHC (2003)
INSTALLATION SERVICE POINTS
>A< REAR WINDOW GLASS INSTALLATION
1. When installing the rear window glass, temporarily fit the window to the body and make matching marks on the body and window glass.
2. Degrease the inner perimeter of the rear window glass and the flange on the body side with iso-propanol (IPA).
3. Soak a sponge in primer and apply uniformly to the specified locations on the entire perimeter of the window and body.
4. Allow to dry for 3 to 30 minutes after applying primer.
Specified primer:
3M ATD Part No. 8608 Super Fast Urethane Primer or equivalent.
CAUTION:
1. The primer strengthens the adhesive strength, so be sure to apply it evenly around the entire circumference. But, a too thick application will
cause lowering of the adhesive strength.
2. Do not touch the coated surface.
CAUTION: If heat is applied with an infra-red lamp to shorten the setting time, keep the surface temperature of the adhesive below 60 °C
(140 °F).
5. Fill a sealant gun with adhesive within 30 minutes of applying primer and apply uniformly to the entire perimeter of the rear window.
NOTE: Cutting a V-shape in the tip of the sealant gun nozzle will facilitate application.
6. After applying the adhesive, install the rear window glass, matching the marks on the glass and body.
7. Remove any excess adhesive with a spatula and clean with isopropyl alcohol.
8. Allow the adhesive to dry for 30 minutes or more and then test for water leakage.
CAUTION: If moving the vehicle, it should be done gently.
CAUTION: When testing for water leakage, do not pinch the end of the hose to spray the water.
