Diamante Sedan V6-2972cc 3.0L DOHC (1993)
Fig. 2 Servicing Hub, Knuckle & Bearing
1. Replace hub, knuckle and bearing in numbered sequence shown in Fig. 1 and 2, noting the following:
a. Use care when handling pole piece at tip of speed sensor and toothed edge of rotor, if equipped.
b. Apply brake pressure, then remove driveshaft nut. Do not apply vehicle weight to wheel bearing while loosening driveshaft nut.
c. Disconnect ball joint and tie rod end using steering linkage puller tool No. MB990635-01, or equivalent. Loosen but do not remove ball
joint and tie rod end nuts until knuckle is ready to be removed.
d. Using axle puller tool No. MB990241-01, or equivalent, press driveshaft from front hub.
