Diamante Sedan V6-3.5L SOHC (1999)
Throttle Full Close Switch: Adjustments
CLOSED THROTTLE POSITION SWITCH AND ACCELERATOR PEDAL POSITION SENSOR ADJUSTMENT
1. Connect the scan tool to the data link connector. When not using the scan tool, proceed as follows.
1. Disconnect the connector of the accelerator pedal position sensor.
2. Connect an ohmmeter between terminal 3 (closed throttle position switch) and terminal 4 (sensor ground) by using jumper wires.
2. Insert a feeler gauge with a thickness of 0.85 mm (0.0334 in.) between the levers shown in the illustration to a depth of no more than 3 mm
(0.1181 in.)
NOTE: Inserting the feeler gauge more than 3 mm (0.1181 in.) will result in incorrect adjustment.
3. Turn the ignition switch to ON (but do not start the engine).
4. Loosen the accelerator pedal position sensor mounting bolt; then turn the accelerator pedal position sensor body counter clockwise as far as it will
go.
5. In this condition, make sure that the closed throttle position switch is ON. (There is continuity between terminals 3 and 4.)
6. Slowly turn the accelerator pedal position sensor clockwise until the point at which the closed throttle position switch is turned OFF (continuity
between terminals 1 and 2 changes to non-continuity) is found.
Tighten the accelerator pedal position sensor installation bolt at that position.
