Diamante Sedan V6-3.5L SOHC (1999)
7. When using the scan tool, select "Traction Control System". When not using the scan tool, proceed as follows.
1. Disconnect the accelerator pedal position sensor connector and connect the special tool (test harness:MB991348) in between.
2. Connect a digital voltmeter between terminal 2 (sensor output) and terminal 4 (sensor ground).
3. Turn the ignition switch to ON (but do not start the engine.
8. Check the accelerator pedal position sensor output voltage.
Standard value: 400 - 1,000 mV
9. If the voltage is outside the standard value, check the accelerator pedal position sensor and related harnesses.
10. Remove the feeler gauge.
11. Turn the ignition switch to OFF
12. Disconnect the scan tool.
When the Scan tool is lot used, remove the special tool and connect the accelerator pedal position sensor.