Diamante Sedan V6-3.5L SOHC (1999)
Crankshaft Position Sensor: Testing and Inspection
CAMSHAFT POSITION SENSOR AND CRANKSHAFT POSITION SENSOR
Measurement Method
1. Disconnect the distributor (camshaft position sensor) connector and connect the special tool (test harness: MB991348) in between. (All terminals
should be connected.)
2. Connect the analyzer special patterns pickup to distributor connector terminal 5.
3. Disconnect the crankshaft position sensor connector and connect the special tool (test harness: MD998478) in between.
4. Connect the analyzer; special patterns pickup to crankshaft position sensor connector terminal 2.
Alternate method Crest harness not available)
1. Connect the analyzer special patterns pickup to ECM terminal 56. (When checking the camshaft position sensor signal wave pattern)
2. Connect the analyzer special patterns pickup to ECM terminal 45. (When checking the crankshaft position sensor signal wave pattern)
Standard Wave Pattern
Observation conditions
