Adjustments for Front Door Window Glass - System Information | Diamante Sedan V6
5. Hold the up stops against the regulator lift arm and tighten.
6. Verify the "soft touch" setting and if necessary adjust by turning the glass track upper studs.
NOTE: Rear glass has two soft touch adjusters, always adjust rear track upper attachments to maximum outer then adjust front track upper
attachments inwards to avoid glass digging into weatherstrip at "B" pillar.
7. Lower and raise the door glass and verify that all dimensions are correct.
Alter glass intrusion by moving the up stops. Alter "soft touch" by adjusting the guide track upper studs. If glass margin is incorrect repeat steps
3-7.
8. Install the waterproof film and door trim.
9. Perform a leak test to confirm that water does not leak into the interior.
CAUTION: To avoid rattles and thread damage always ensure each adjustment stud/bolt has a minimum of one and a half threads of protrusion
and are equal at stabilizers and lower track attachments.
