Eclipse L4-1795cc 1.8L SOHC (1990)
(1) Apply the specified compressor oil on the shaft.
Specified compressor oil: DENSO OIL 6 or SUNISO 5G5
(2) Taking care to prevent injuring the lip area of the shaft tool, mount the front housing.
(3) Mount the bolt on the shaft, and then measure the shaft starting torque.
Standard value: 5.0 Nm (43 in.lbs.) or less
(4) Remove the bolt from the shaft. A
6. INSTALLATION OF CLUTCH COIL
The clutch coil must be aligned with the pin in the compression housing.
1. INSTALLATION OF CLUTCH HUB
(1) Connect the magnetic clutch to the battery.
(2) The clutch hub will be attracted to and fit closely to the rotor.
(3) Use a shim(s) to adjust so that the amount of movement of the clutch hub is as described below.
Standard value: 0.35-0.65 mm (.014- .026 in.)
NOTE Remove clearance adjusting shims to decrease clutch clearance. Add shims selected from the following table to increase clutch
