mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

A/C Switch - Installation Procedure Change|Page 749 > < Oil Pressure Sending Unit - Two Units
Page 1
background image

Air Conditioning Switch: Technical Service Bulletins
A/C Switch - Installation Procedure Change

SUBJECT:

A/C SWITCH INSTALLATION ON ECLIPSE MANUAL CHANGE

NO:

TSB-89-24-001

DATE:

May, 1989

MODEL 1990 ECLIPSE

PURPOSE The 1990 Eclipse A/C installation manual steps 4 and 5 incorrectly describe how to install the dash panel switch. This bulletin describes a
corrected procedure for steps 4 and 5. As a reference to this bulletin, please cross out steps 4 and 5 in the A/C installation manual. Detach and place the
attached sheet with the revised steps 4 and 5 between pages 14 and 15.

AFFECTED MANUAL 1990 Eclipse Air Conditioner Installation Manual MSSP-MF-90 Pages 13 & 14, steps 4 and 5.

DETAILS OF CHANGE The manual currently describes installing the A/C switch from the front of the dash panel by pulling the switch wiring harness
through the switch hole. However, the switch wiring harness is not long enough to do this; the switch must be guided through the hole and held while the
harness is connected to it from the back side. The attached sheet describes the correct procedure and should be placed in the A/C installation manual as
directed.

FIGURE 11

CHANGE TO MANUAL # MAC-2010:

4.

A/C SWITCH

a.

Remove the 3 screw covers and screws from the passenger side of the center console and remove the side panel.

FIGURE 12

A/C Switch - Installation Procedure Change|Page 749 > < Oil Pressure Sending Unit - Two Units